|Wash Basins||1. Water deposit on trap platform
and inside bowl.
|1. Wash Basin is not fixed in level, Bracket not leveled.||1. Bracket should be corrected.|
|2. Overflow cjocked & foul smell.||2. Waste coupling used may be
|2. Waste coupling should be
changed to slot cut coupling.
|EWCs / Indian Pan||1. Water not coming in bowl
|1. Flush bend may be inserted up
to the end of inlet hole.
|1. Insert the flush pipe only up to
the locking portion of the inlet.
|2. Flush pipe end may be padded
with cloth, etc.
|2. Flush pipe should be used with
|3. Closet/ Pan may not be
|3. Closet/Pan should be levelled.|
Floor Mounted /
Wall Mounted WCs
|1. Water leaking between cistern
|1. Diverter pipe not fixed in outlet
|1. Insert the diverter pipe into
the outlet of the cistern.
|2. Uneven flow of water from
|2. Both arms of the diverter pipe
not inserted equally in both
sides of the closet.
|2. Both arms should be properly
inserted inside both sides of
|Twin-flush WCs||1. Push rod short and not
|1. Rubber step washer may be
fixed outside the cistern
reducing the height of the out
|1. Rubber step washer should be
used in the outlet of outflow
valve from inside the cistern.
|Coupled Closets||1. Water leaking between the
cistern and the closet during
|1. Rubber ring gasket may not
fixed or not fixed properly.
|1. Rubber ring should be kept in
the center between the outlet
of the cistern and the inlet of
the closet at correct position.
|2. Water quantity insufficient for
|2. Float ball height adjusted to
lower quantity of water
|2. Turn the adjusting screw
provided on the top of the
inlet in clock wise direction to
increase the discharge level.
(Caution: The water level may
be increased till the water from
the inlet shuts off at the ‘top-
line’ mark provided on the
|Cisterns||1. Water overflowing
continuously from the cistern.
|1. Inlet valve may not be closing
|1. Inlet valve should be opened
to clean the rubber diaphragm.
See that the diaphragm is not
|2. Water leaking from outlet of
the cistern continuously.
|2a. Outflow valve may not be
|2a. Open the outflow valve top
portion and clean the
washer, if there is any dirt
|2b. Valve ring may not be fixed
properly to the bottom of the
|2b. Fix the valve ring to the top
of the groove provided in the
floating body. Ensure that
the valve ring sits securely
around the groove.
|2c. Valve ring may have cracked
or become worn out.
|2c. Replace the valve ring.|
|2d. Cistern not fully tightened to
|2d. Tighten tank holding screws
evenly till they cannot be
tightened further with one